Metal Tech Lexus GX460 Lancer Rear Swing Out Bumper (2010+)

Metal Tech 4x4 Lexus GX460 Lancer Swing Out Rear Bumper

*This bumper comes RAW. Powder coating optional.

Fuel can holders (Stage 3 Bumper) - full built vehicle pictures show previous design - see the new design HERE

Installation videos:  

Mounting your bumper

Swing arm install

Print instructions

 Stage 1 comes with:

• Bumper shell
• Swing out arm w/ tire carrier and license plate mount
• Hi-Lift Jack mount
• Antenna mount
• Side Step Pockets for optional power ports and LED step lights
• Stainless Steel latch with HDPE landing pads
• All mounting hardware
• Rear pockets for optional LED back up lights
• Weight 165lbs 

Stage 2 comes with :

• Bumper shell
• Swing out arm w/ tire carrier and license plate mount
• Hi-Lift Jack mount
• Antenna mount
• Side Step Pockets for optional power ports and LED step lights
• Stainless Steel latch with HDPE landing pads
• All mounting hardware
• Rear pockets for optional LED back up lights
• + 2 OPOR Flange Mount Reverse LED Lights
• Weight 169lbs

 Stage 3 comes with:

• Bumper shell
• Swing out arm w/ tire carrier and license plate mount
• Hi-Lift Jack mount
• Antenna mount
• Side Step Pockets for optional power ports and LED step lights
• Stainless Steel latch with HDPE landing pads
• All mounting hardware
• Rear pockets for optional LED back up lights
• + 2 OPOR Flange Mount Reverse LED Lights
• + 2 Metal Tech Locking Steel Fuel/Water Can Holders and utility rack(s)
• Weight 203lbs

Optional Accessories:

• Metal-Tech Standard Receiver (SKU #MT-34217)
• OPOR 20w LED Flange Mount Flood Light (SKU #OPOR-LED-DM03-12AM-F)
• OPOR Rear License Plate LED Lights (SKU #OPOR-LED-LP)
• OPOR 12v Dual Plugs for step pockets (SKU #OPOR-54213)
• OPOR LED Step Lights for step pockets (SKU #OPOR-54812)

Estimated Install Time: 7 hours

GX460 Rock Slider Information:

GX460 Rock Sliders (SKU# OPOR-GX460-21000)

| HOW TO PAINT RAW SLIDERS | Install Guide |

The Lexus GX460 Lancer rear bumper is a proven overland platform known around the world as a Land Cruiser Prado 150. We designed, engineered, and tested the Lancer rear swing out bumper to give you added utility and protection needed while using serviceable and replaceable moving parts so the bumper keeps performing the life of the product.   

The Lexus GX460 Lancer rear bumper uses our custom machined 2000lb Motion X Pivot System with two tapered radial bearings and grease seal that move the swing out arm with ease, even when fully loaded with accessories.  The swing out is assisted by an integrated 120lb gas strut, auto locking in the open and closed positions to make opening while the vehicle is off axis safe and easy.

Disclaimer:  Stage 3 Bumper shown

Blind Spot monitoring system on most instances is not compatible w/o adjusting the sensors.  The sensors can be adjusted in their mounting to allow the blind spot monitoring to work with the bumper. However Toyota/Lexus did make this system something you can turn on or off at the "control" screen on the dash as the driver.