2010-2013 GX460 Lancer Rear Bumper

Description
Additional Information

Metal Tech 4x4 Lexus GX460 Lancer Swing Out Rear Bumper - Stage 1

Install Guide

Stage 1 comes with:

Bumper shell
Swing out arm w/ tire carrier and license plate mount
Hi-Lift Jack mount
Antenna mount
Rear pockets for optional LED back up lights
Side Step Pockets for optional power ports and LED step lights
Stainless Steel latch with HDPE landing pads
All mounting hardware
weight 165lbs

Optional Accessories:

Metal-Tech Standard Receiver (SKU #MT-34217)
OPOR 20w LED Flange Mount Flood Light (SKU #OPOR-LED-DM03-12AM-F)
OPOR Rear License Plate LED Lights (SKU #OPOR-LED-LP)
OPOR 12v Dual Plugs for step pockets (SKU #OPOR-54213)
OPOR LED Step Lights for step pockets (SKU #OPOR-54812)

Estimated Install Time: 7 hours

ADDITIONAL INFO ABOUT OUR SLIDERS

Raw Sliders (SKU# OPOR-GX460-21000)

Powder Sliders (SKU #OPOR-GX460-21100)

| HOW TO PAINT RAW SLIDERS | Install Guide |

The Lexus GX460 Lancer rear bumper is a proven overland platform known around the world as a Land Cruiser Prado 150. We designed, engineered, and tested the Lancer rear swing out bumper to give you added utility and protection needed while using serviceable and replaceable moving parts so the bumper keeps performing the life of the product.

The Lexus GX460 Lancer rear bumper uses our custom machined 2000lb Motion X Pivot System with two tapered radial bearings and grease seal that move the swing out arm with ease, even when fully loaded with accessories. The swing out is assisted by an integrated 120lb gas strut, auto locking in the open and closed positions to make opening while the vehicle is off axis safe and easy.

The swing out beam features an adjustable and lockable offset spare tire mount holding up to a 35" spare without blocking the tail lights and a license plate mount. There is a built in horizontal Hi-Lift Jack mount located low on the swing arm beam and a UHF/CB antenna mounting point up high. The swing arm is secured in place with a stainless steel 2000lb rated locking latch resting on machined High-density polyethylene (HDPE) replaceable wear blocks for the swing arm contact points into the locking cradle preventing metal on metal wear and rattling on the trail, and a long service life.

We integrated 3/4" recovery points in line with the chassis for strong and reliable rigging in recovery situations. The bumper shell features rear facing cut outs for optional 20w flange mount LED backup lights helping illuminate the trail while reversing. There are two laser cut side step pockets on both sides of the bumper to make roof cargo access easier. The step pockets have cut outs for optional 12v marine grade power ports and LED step lights. We also designed this rear swing out bumper to work with the factory Lexus back up sensors for added convenience.

We offer two optional bolt on receiver hitches, (1) under frame mount full GVW towing capacity, (2) high tuck above the frame with light duty use like small off road trailer or bike carriers etc.

Make:: Lexus
Model:: GX460
Year:: 2010
Year:: 2011
Year:: 2012
Year:: 2013
Year:: 2014
Year:: 2015
Year:: 2016
Year:: 2017
Year:: 2018
Year:: 2019